Items:
Value:
 

USED SUPER 7 LATHE WITH VARIABLE SPEED CONTROL - SK171154 SOLD

Ref: 2738
 
USED SUPER 7 LATHE WITH VARIABLE SPEED CONTROL - SK171154 SOLD
This Super 7 lathe is fitted to a standard cabinet, with drip tray and raising blocks. The bed has been induction hardened.

This lathe comes fitted to an imperial quick change gearbox, which, when used in conjunction with the 8TPI leadscrew, gives 24 imperial/inch threads, and 24 feeds. A thread dial indicator is fitted to the apron. (For metric, BA, threads and odd pitches, the metric conversion kit will be required)

The carriage features power cross feed (facing), a tee-slotted cross slide, and the top slide swivels 360 degrees. Both top slide and cross slide feedscrews are fitted with adjustable micrometer dials.

The tailstock is a self-ejecting type, and the barrel feedscrew has a three start thread to give rapid movement. The barrel is precision bored 2MT. The tailstock body can be set over on its base in either direction to turn long, shallow tapers.

The machine is fitted with a countershaft clutch unit. A plain taper front headstock bearing supports the spindle in radial loading, while a pair of angular contact ball races at the rear provide support for axial loads, the spindle nose is threaded M42.5 x 2mm pitch. The bullwheel has 60 teeth, 14 spindle speeds, ranging from 27-2105rpm, which are achieved by a two-speed drive from the motor to countershaft, a four-speed drive from the countershaft to headstock spindle, and a backgear reduction.

The machine also benefits from a Myford quick change toolpost, with 2 standard holders, fitted on a long tee slotted cross slide, to allow milling on the lathe.

The previous owner of this lathe fitted a Newton Tesla variable speed control unit to this lathe (ML750), allowing you to take precise control of the spindle speeds. This makes using the lathe a much quicker and easier process.

STANDARD EQUIPMENT COMPRISES OF:
125mm (5") 3 jaw Bison chuck fitted to a backplate
150mm (6") 4 jaw independent Bison chuck fitted to a backplate
4MT - 2MT Headstock Reducer
2MT Soft Centre (for headstock)
2MT Hard Centre (for tailstock)
Catchplate with Driver Peg
Big Bore Faceplate (9 3/4")
Travelling Steady
Thread Dial Indicator (gearbox models only)
Leadscrew Handwheel and Pointer (fitted to imperial machines only)
Oil Gun
Installation and Instruction Manual
Quick Change Gearbox Manual
Litre of Lubricating Oil Esso Nuto 32
Litre of Lubricating Oil ISO VG 68



SOLD

Free UK Mainland Postage