NEW 2MT ER25 COLLET CHUCK

Ref: 2192
This collet chuck is the new design for Myford only. It is a 2mt chuck with a 10mm draw bar thread. It is designed to ... Read More

NEW ER25 COLLET CHUCK WITH FULL SET OF ER25 COLLETS

Ref: 2194
This collet chuck is the new design for Myford only. It is a 2mt chuck with a 10mm draw bar thread. It is designed to ... Read More

ER25 COLLET NOSE ADAPTOR ASSEMBLY (SMALL BORE) 20/294

Ref: 1433
Comes complete with collet nose adaptor and backplate, clamping nut and spanner/wrench. To suit older small bore series 10 and 7 lathes with spindle noses bored ... Read More

ER25 COLLET SET 78261

Ref: 942
Set of 15 ER 25 Collets ranging in size from 2mm-16mm in 1mm increments. Picture may differ slightly as the new stock has an aluminium case Read More

ER25 SPANNER

Ref: 3441
Industrial type spanner for the ER25 collet nuts Read More

ER32 SPANNER

Ref: 3442
Industrial type spanner for the ER32 collet nuts Read More

ER 40 SPANNER 78251

Ref: 872
Industrial type spanner for the ER40 collet nuts Read More

COLLET CLOSING TUBE 2MT 1439

Ref: 1259
2MT collet closing tube. This is only used on the old genuine Myford 2MT collets. Used to close the collet, to remove it from the collet ... Read More

COLLET NOSE PIECE 2MT 1438

Ref: 1065
This collet nose piece holds the original 2MT collet and screws directly on to the Myford spindle (only suitable for spindles threaded 1 1/8" x 12TPI) Read More