Items:
Value:
 

K68. LONG CROSS SLIDE A2060/2

Ref: 675
 
K68. LONG CROSS SLIDE  A2060/2
Cross slide for Super 7 lathes.
Comes complete with gib strips and adjusting screws

PLEASE NOTE:

This cross slide comes without the holes for the end plate drilled. This is because the height of this can vary from lathe to lathe, and to get the optimal performance, you should do this when the cross slide is on your lathe. Failure to do this correctly can cause excessive wear in the feednut, as the feedscrew and bracket will not be aligned properly:

First, assemble the feedscrew in the bracket, and slide your new cross slide in place (on to the dovetail). Screw the feedscrew into the feednut, so that the bracket is now pushed up against the cross slide. Next, use some toolmakers clamps to align the bracket, and make sure that it is at the correct height. Spot through the holes of the bracket for drilling.

Next, using a stand drill, drill the holes into the cross slide (the holes should go in roughly 3/4"). These were originally tapped 2BA, but M5 will do just as well if this is easier to come by.


Free UK Mainland Postage


Price: 139.50

(167.40 Inc VAT )


People who bought this item also bought: